cushion-tops. If you have a washer cold water hose attached to the cold water faucet, unscrew and remove the hose. For easy access, we recommend you install the dryer in the same location as your washer. You can damage the coupling. Remove the protective cap from the gas pipe.
If you detached the cold water hose from your washer, attach the hose to the open end of the Y connector, tighten the coupling until it is tight, and then, using a pliers, tighten an additional two-thirds turn. When you convert from the 3-prong to the 4-prong configuration, you must make sure that the dryer's neutral terminal is not connected to the case ground.
Secure the dating someone who wants to wait for sex cover with a hold-down screw. Before the change, dryers used 3-prong cords that plugged into 3-slot electrical outlets (receptacles). Extending the leveling feet more than necessary can cause the dryer to vibrate. If you detached the cold water hose from your washer, attach the hose to the free end of the Y connector, tighten the coupling by hand until it is tight, and then, using a pliers, tighten an additional two-thirds turn. That's why the cords are sold separately. Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the terminal block. If the gas does not ignite within 5 minutes, turn your dryer off and wait 5 minutes. If the dryer is not level, adjust the leveling feet (B) at the bottom of the dryer. What Is the Difference in Wiring? Allowing your dryer to operate on a heat setting will purge the line. A strain relief must be used.
Best hookup site app
Snapchat hookup stories
Reddit gay hookup